Los Angeles Fabrics™ Installation Guide

Before You Begin

Surface Preparation

• 1 Clean the Surface: Ensure walls are clean, dry, and smooth. Remove any loose paint, wallpaper, or debris.
• 2 Prime the Walls: Apply a high-quality primer-sealer to create a uniform surface and improve adhesion.
• 3 Check for Moisture: Test walls for moisture content. Walls must be completely dry before installation.

Required Tools & Materials

Installation Steps

Measuring and Cutting

• 1 Measure Carefully: Measure wall height and add 2-3 inches to both top and bottom for trimming allowance.
• 2 Check Pattern Direction: Ensure all panels are cut in the same direction to maintain consistent appearance.
• 3 Number Panels: Lightly mark the back of each panel with its position number.

Applying Adhesive

• 1 Choose Right Adhesive: Use a heavy-duty, clear-drying wallcovering adhesive recommended for fabric-backed materials.
• 2 Apply to Wall: Roll adhesive evenly on the wall area where the first panel will be installed.
• 3 Work in Sections: Apply adhesive to one panel width at a time to prevent premature drying.

Hanging the Material

• 1 Position First Panel: Start at a plumb line or corner. Carefully position the panel with excess at top and bottom.
• 2 Smooth Gently: Use a smoothing brush to remove air bubbles, working from center outward.
• 3 Align Seams: Butt seams tightly together without overlapping. Use a seam roller gently to secure edges.
• 4 Trim Excess: Once positioned correctly, trim excess material at ceiling and baseboard with a sharp blade.

Special Considerations

Working with Los Angeles Fabrics™

• Temperature: Install in room temperature between 65-85°F (18-29°C) for best results.
• Humidity: Maintain relative humidity between 30-50% during installation.
• Directional Nap: Los Angeles Fabrics™ has a directional nap. Install all panels in the same direction for uniform appearance.
• Avoid Stretching: Do not stretch the material during installation as it may cause distortion.

Finishing Touches

• 1 Inspect Seams: Check all seams are properly aligned and secured.
• 2 Clean Surface: Gently vacuum or brush the surface to remove any debris.
• 3 Allow to Set: Let the installation cure for 24-48 hours before heavy use of the space.

Troubleshooting

Common Issues and Solutions

• Bubbles or Wrinkles: Gently lift the affected area and reapply, smoothing carefully from center outward.
• Visible Seams: Ensure panels are butted tightly together and all panels are hung in the same direction.
• Adhesive on Face: Immediately clean with a slightly damp, clean white cloth. Do not rub vigorously.
• Color Variations: This may occur if panels are installed in different directions. Always maintain consistent direction.

Professional Installation

For best results, we recommend professional installation by experienced wallcovering installers familiar with premium textile materials. Contact your local installer or interior designer for recommendations.